Drew Snodgrass
Articles
-
iPadOS 26 MDM Migration
You will be prompted with an Enrollment Required message:Touch Start Enrollment.If Now Now is pressed, the enrollment can be started by going into settings or once the required date is reached.Touc...
-
Updating Firmware Using the Firmware Portal (CloudBox 2)
InstallationConnect to the FuelCloud Wi-Fi network on a laptop or phone. The Wi-Fi SSID will be FMS_XXXXX where XXXXX are the last five digits of the CloudBox serial number.Open a web browser (Inte...
-
Pulser Wiring Best Practices
Pulser wires are required to be in separate conduit than AC power wires by the NEC & local fire code. The shield of the pulser wire should be connected to earth on one end only. Do not earth ...
-
CloudBox 2 M.2 Wi-Fi Card Replacement
Update the CloudBox 2 OS.Once the CloudBox 2 has booted up and is showing a green status LED, flip the power switch in the top right down to power off.The M.2 Wi-Fi card is located directly to th...
-
Ethernet Client Mode
Prerequisites CloudBox 1.0-2.0 CloudBox 1.0-1.4 firmware is 3.57 or higher CloudBox 2 OS is on 1.0 or higher Can be checked in the devices page on the FuelCloud website. Installation Connec...
-
CloudBox V1.0-1.4 Firmware Download
3.57.79 3.57.76
-
Pulser Compatibility Guide (Includes Registers, Meters & Dispensers)
Overview Updated: 09/25/2024 The CloudBox & CloudLink have 3 terminals used to connect a pulser to the system. The 3 terminals are used for pulser power, pulse input, and ground. The CloudBox a...