Audra Kelvin
Articles
-
Restriction Groups
Access Groups let you easily manage restrictions for a large fleet of drivers and vehicles. Each access group must contain at least one driver, vehicle, and tank. Drivers, tanks, and vehicles can b...
-
Adding a Vehicle
Vehicles can be added in the My Assets section of your account. To add a vehicle: Go to My Assets and select Vehicles Select Add a Vehicle (top right) Enter Vehicle Name as you would like ...
-
Adding a Driver
FuelCloud Allows unlimited drivers to be added to the website. Here are instructions for manually adding Drivers. Go to My Assets-Drivers Click on Add Drivers- Enter Driver information Cl...
-
Adding a Site
Sites are where your fuel tanks and hardware are configured. Sites can be added in the My Assets section of your account. Go to My Assets- Sites Under Manage Click on Sites Select Add Site En...
-
Adding a Tank
Tanks can be added in the My Assets-Tanks section of your account. When adding a tank, it must be assigned to a Site. To add a tank: Go to My Assets and select Tanks On the Tanks page, click Add T...
-
FuelCloud Fuse Replacement and Specs
CloudLinks and 1.0-1.3 CloudBoxes are equipped with fuses to protect the hardware in the event of an electrical issue. Below you will find details on fuse requirements and replacement. If your devi...
-
Powering On Your CloudLink
Power On & Verification After installing the FuelCloud hardware and restoring power to the pump, verify the following items: 1. Power to the hardware: Check that there are lights on the FuelCloud ...
-
CloudLink V1.4 Wiring Diagram
FuelCloud Hardware Power In / Power Out FuelCloud piggybacks power off of the AC input. Your wiring configuration will depend on whether the pump runs on AC or DC power. For use with DC application...
-
WiFi Connection Overview
To Connect your mobile device to the FuelCloud hardware users must connect to the FuelCloud WiFi Network. The FuelCloud WiFi Network is listed as FuelCloud_XXXXX (Last 5 of the CloudBox serial Numb...
-
Driver/Vehicle QR Codes
To replace the PIN entry and Vehicle Selection steps in the app, you can use the device camera to scan a QR Code. Select your Pump From the Driver PIN entry, Select Scan QR Allow access to the...